Bobber on 2040-motos
Year:
Mileage:2000
Color:
Harley-Davidson Bobber description
New build by Lock Jaw Customs with HAMMER Performance motor. VERY fast VROD destroyer. These guys only build one to two bikes a year so the attention to detail is incredible. There is different Custom Leather seat on the bike than shown in most of the pics...same style just better fit. 2 into 1 custom exhaust with new heat tape, Moty 8 cell battery, custom bars, Joker pegs and levers, powder coated frame, bottle opener points cover (coolest add). Bike has a 1250 Hammer motor with huge torque numbers. Research HAMMER PERFORMANCE to see the goods.
It uses standard Harley Davidson softail rear brake pads, it does have new in it now, standard Harley brake fluid, hammer performance recommends no lower than 89 octane. I have run it with 93 since the engine kit installed. It has one inline fuse under the bike that is for all the wiring. The wiring is clean and simple and not a rats nest. Battery is a Moty engineering lipo battery. It's a 8 cell and does not need to be charged as long as you take it out in the cold months (below freezing) and put it inside and keep it stored at room temp. In the event you would need to charge there is a plug on the side of it. Lightweight and used by those going fast. It's a trick little battery.
When you start it, pull the choke out, let it idle for about a minute or two. The carb is setup with a 185/45 jet setup and the fuel mixture is turned 3 turns out. The carb has been tuned for the velocity stack and exhaust. The stack does have a multilayer filter screen in it and it is washable. Bike is loaded with all stainless steel bolts, motor and frame. New rubber motor mounts also, those will last for years. 0 tolerance custom shims built for the hub bearings. This is an incredible build that WILL NOT disappoint. I'll be glad to send video upon request.
Bike is for sale local and reserve the right to end this listing if sold.
Serious inquiries only please.
Harley-Davidson Bobber for Sale
Bobber(US $8,000.00)
2011 harley-davidson bobber(US $7,900.00)
2004 custom built motorcycles bobber(US $19492)
2004 custom built motorcycles bobber(US $36000)
2002 custom built motorcycles bobber(US $7,200.00)
2006 custom built motorcycles bobber(US $27000)
Moto blog
35 years ago this month
Fri, 28 May 2010IT'S 35 YEARS since Evel Knievel attempted to jump 13 London buses at Wembley Stadium. Riding a heavy, slow Harley-Davidson XR750, the American daredevil had serious reservations about the jump, admitting the take-off ramp was too short, therefore limiting the bike's speed. But even though the plucky American knew his chances of pulling off the stunt were slim, he was reluctant to disappoint the 80,000-strong Wembley crowd.
2013 AIMExpo: Rekluse Clutches – Video
Thu, 24 Oct 2013Perhaps the biggest name is aftermarket clutches, Rekluse Motorsports featured two new Harley-Davidson clutch systems at the American International Motorcycle Expo. The Rekluse Torq Drive auto clutch system is designed to increase torque capacity by 17% to the general clutch system. This is a very simple system and no modifications are needed to install the auto clutch.
Get A Harley-Davidson Demo Ride At American International Motorcycle Expo
Thu, 18 Sep 2014From a press release issued by AIMExpo: The American International Motorcycle Expo (AIMExpo) announced today that the Harley-Davidson Demo Fleet will be featured at the 2014 event, offering test rides of the legendary company’s 2015 models. Additionally, Orlando Harley-Davidson becomes the newest exhibitor to join AIMExpo, which will host nearly 500 powersports companies from around the world October 16-19 at Orlando’s Orange County Convention Center (OCCC). The presence of the Harley-Davidson brand at AIMExpo for the first time adds to the growing excitement surrounding the 2014 event, now less than a month away.
Harley-Davidson Bobber by State
| Harley-Davidson Bobber by City
| Harley-Davidson Bobber by Color
|