1987 Kawasaki Vulcan on 2040-motos

Greetings,

This was a project bike of mine and it is almost done. I am selling it because I am really a fan of old inline 4 cylinder bikes and I just got one in on a trade so I want my lift free to work on it. V-Twins? Meh....just not my thing.

I had to split the case to replace a broken shift shaft tie rod (see pics). So the engine has been completely gone through. The bike fires right up and idles fine.

The bike has new....(and when I say new I mean zero miles):
*New front brake pads, caliper pistons, new seals and new braided steel brake lines
*New fork gaiters
*New tires front and rear
*All new control cables
*Fresh Army theme OD Green paint and graphics
*New seat covering material supplied
*New single Mikuni Round Slide VM Series Carburetor - 38mm
*Custom fabricated fueling rail for carb
*Have original carbs if you want to go that route (just ask me about that) :)
*Custom straight pipe exhaust wrapped with header tape (yes it is loud)
*Shocks and forks serviced with new oil
*New front brake master cylinder

I have all the radiator cowlings and misc stock pieces in a box along with the original seat and covering material if you want to use it. I was going to put a solo bobber seat on it.

What the bike needs:
*Front brake fluid and lines bled
*Radiator shrouds screwed in place
*decide on a seat and install
*run fuel lines for tank (I used a fueling bottle to run it)
*shaft drive final drive housing needs to have oil added

Will entertain reasonable offers. I want it gone.

Can't think of anything else right now. Give it some love and enjoy.

I will not ship.  You can have it picked up if you like.  I will give signed Florida title to person picking up bike.