Brand new aftermarket generator stator

Plug-and-play, direct fit, easy installation

All products shipped are tested

Direct replacement to your original unit

All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part

Battery condition is important. No stator can make up for a bad or weak battery. If in doubt charge your battery and have it load tested, or simply replace it. ALWAYS START WITH A FULLY CHARGED BATTERY !

Brand new aftermarket Generator Stator

• Direct replacement to your original unit
• Plug-and-play, direct fit, easy installation
• Highest grade of lamination materials
• Highest grade of copper winding, resistant to 200 degrees Celsius.
• Connector included
• Rubber grommet included
• All products shipped are tested

We have even included the opposite connector (main harness side) as we know these are often melted / corroded / defective and a major cause of repetitive electrical issues.

All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part.

Husaberg FS 550 E -- 2005-2008
Husaberg FS 550 S -- 2005
Husaberg FS 650 C -- 2005-2008
Husaberg FS 650 E -- 2005-2008

80039004000
59039104000
59039104200
77039104000

Dimensions :
Interior diameter : 29 mm
Exterior diameter : 83 mm
Thickness : 13 mm
Length of wires stator to grommet : 60 mm
Length of wires grommet to plug : 490 mm

Other specifications :
Number of wires : 4
Number of plugs : 3
Number of pins : 4

Wire to wire resistance :
Alternator :White to Yellow = 0.5 ohms +-20%
Source: Black/Red to Red/White = 30 ohms +-20%

Before installing your new Generator Stator

• Check the AC output of the stator
• Replace any burned or corroded connectors on stator and regulator rectifier
• Check and repair any melted wiring
• Use hi-temp dielectric grease on all connectors

Our stator may use a different wire color code than your original.
All the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".

Our multiple North American locations, from which we ship our products, allows us to deliver 99.7% of our orders within the specified time period. If your item is not available in our main Colorado facility, we still guarantee that your order will be delivered within the specified time period.

If your item is not delivered within this time period, we will offer you a 5.00$ discount on your order. This guarantee applies to shipments delivered in the 48 continental USA states, excluding PO boxes.