50W Lighting Stator for Husaberg FC 450 / FC 550 2004 2005 OEM Repl.# 80039004100
 
KEY FEATURES
 

Brand new aftermarket stator

Direct replacement to your original unit

Plug-and-play, direct fit, easy installation

All products shipped are tested

DESCRIPTION

 

Please note : We suggest using a 35W halogen bulb in the headlight with our RM03800 12V AC regulator, which will ensure a good lighting output at most RPMs you will be running your KTM at.

Battery condition is important. No stator can make up for a bad or weak battery. If in doubt charge your battery and have it load tested, or simply replace it. ALWAYS START WITH A FULLY CHARGED BATTERY !

Brand new aftermarket 50W lighting stator

  • Direct replacement to your original unit
  • Plug-and-play, direct fit, easy installation
  • Highest grade lamination materials
  • Highest grade copper windings, resistant to 200 degrees Celsius.
  • Connector included
  • Rubber grommet included
  • All products shipped are tested

We have even included the opposite connector (main harness side) as we know these are often melted / corroded / defective and a major cause for repetitive electrical issues.

All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.

Vehicle models fitment

 

Husaberg FC 450 -- 2004-2005
Husaberg FC 550 -- 2004-2005

OEM part replacement

 

59039004000
80039004100
77039004000

Specifications

 

Dimensions :
Interior diameter : 28 mm
Exterior diameter :58 mm
Thickness : 28 mm
Length of wires stator to grommet : 130 mm
Length of wires grommet to plug : 400 mm

Other specifications :
Number of wires : 3
Number of plugs : 2
Number of pins : 3
Number of poles : 6

Wire to wire resistance :
Alternator : Black/Red to White/Red = 0.02 ohms +-20%
Alternator to ground = O.L

instructions

 

Before installing your new stator

  • Check the AC output of the stator
  • Replace any burned or corroded connectors on stator and regulatorrectifier
  • Check and repair any melted wiring
  • Use hi-temp dielectric grease on all connectors

Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".

Item Delivery

 

Our multiple North American locations, from which we ship our products, allows us to deliver 99.7% of our orders within the specified time period. If your item is not available in our main Colorado facility, we still guarantee that your order will be delivered within the specified time period.

If your item is not delivered within this time period, we will offer you a 5.00$ discount on your order. This guarantee applies to shipments delivered in the 48 continental USA states, excluding PO boxes.