2022 Harley-Davidson Nightster Review - First Ride

Putting the sport back in. Nightster

The Sportster hasn’t been all that sporty for some time now – that is aside from the 2021 Sportster S that the Nightster shares more than a handful of tricks with. It’s been 65 years since Harley-Davidson introduced the Sportster as America’s answer to the British invasion of bikes that had begun to increase in popularity Stateside around that time. Back then, folks used their motorcycles for everything – drags, trials, enduros, scrambles, hare and hounds, road runs, and Sunday cruising. You could do it all on a Harley according to the 1958 ad for the Sportster CH and C models below. The market wasn’t so segmented.

2022 Harley-Davidson Nightster

That is, of course, not to discredit the history the Sportster model has had in competition. While my 30-something-year-old view of the Sportster knows it as a platform for customizers and the gateway drug into the H-D fold, the dynamic character of the bike is the reason the Sportster line has been so popular since its inception. From enduros and drags of the late ’50s and ’60s, to the hooligan races of today and all of the customized machines along the way, the Sportster has been used in a myriad of ways by enthusiasts of every ilk. With the all-new Nightster, what we have now is a Sportster with some seriously modern sporting capability.

Attainable and easy to ride, with a high performance window

That was the goal for the 2022 Harley-Davidson Nightster. With a 27.8-inch seat height (unladen), a measured wet weight of 482 pounds – most of which is tucked low on the bike – 90 hp, and 70 lb-ft of torque, it sounds like the folks from Milwaukee have put together a good formula for reaching that goal. It wasn’t easy, says VP of Design, Brad Richards. Keeping the classic Sportster DNA was a challenge with the new engine, and particularly so after the switch to using the engine as a stressed member of the chassis as opposed to the traditional “loop” frame Sportsters had been using since the beginning. A similar setup can be found on the Sportster S, but the Nightster was meant to match as closely as possible the silhouette of the Iron 883, so H-D had some work to do.

While we didn’t have an Iron 883 to verify the claim that the riding position and general stance of the bike was very similar, it was easy to see, and from the fancy graphic our man DC put together above, it’s fun to check out the similarities.

In development, the new Revolution Max engine itself was scrutinized for weight savings – seen here in the 975T variant, more on that later – but the Milwaukeeans also engineered weight savings and agility into the bike in other ways.

The Nightster uses a Showa dual-shock suspension system out back with 3 inches(!) of travel adjustable for only spring preload (a skeletal spanner wrench for adjustment is included under the seat, also where you’ll find the fuel filler). Not only does this keep up the classic look, it freed up room under the 27.1-inch tall seat that would otherwise be taken up by a monoshock, so H-D tucked the Nightster’s 3.1 gallon fuel tank underneath, keeping its weight low in the chassis. So, what’s under that steel “almond-shaped” tank cover? You guessed it, the airbox, fed by an intake funnel that sucks air from the engine’s right side beneath a classic round Sportster-esque intake cover.

Harley reps admitted that the previous gen bikes, like the Iron 883, feel a bit top heavy. With the new setup you no longer feel like you’re lifting a solid chunk of lead off of the kickstand when you right the bike. Further acknowledging the previous heft, our presenters warned us to be careful not to put too much work into lifting the bike from its side stand or we might be headed to the other side quicker than expected. They weren’t kidding.

The Motor Co.

As we have been reporting since the Pan America hit the scene, the new Rev Max motor is a peach. In this 975cc T version, the story is much the same but first let’s take a look at how it differs from the Sportster S’s 1250T mill.

To get down to the 975 cc displacement on the 60-degree V-Twin, Harley-Davidson has reduced both bore and stroke by 8mm and 6.3mm respectively. Despite the smaller bore and shorter stroke, the outside of the motor is the exact same size as the 1250T. The smaller bore, we’re told, needs only a single spark to fire efficiently, whereas the 1250 uses dual plugs per cylinder. Both the Nightster and Sportster S share the same 12:1 compression ratio in the T variant of the Rev Max engine, which is down slightly from the Pan America’s 13:1.

As with the previous iterations of the Rev Max, knock sensors are used should you find yourself blasting down to Baja and filling up your tank with gasoline from water bottles – or if you just decide gas has gotten so expensive that you refuse to fill up with the recommended 91 octane.

The same DOHC four-valve head design is used, but now we have variable valve timing only on the intake side. As we’ve said before, thank you Harley for the hydraulic valve lash adjusters that keep the valve train maintenance free. When the engine shuts down, the VVT system sets the intake cams back fully to reduce compression for easy starting – we did however have some issues with hard starting on our last Pan America that also utilizes the system – but I had no issues to report with the Nightster during our 100-mile press ride.

As mentioned previously, the 6.5-liter airbox sits under a steel cover where the iconic tank once sat, which feeds air down-draft style into two 50mm throttle bodies. The airbox’s shape itself has been tuned to quell resonance and muffle intake noise.

Again, not new to the Rev Max motor, but an impressive feature – the dual counterbalancers. This engine is incredibly smooth while cruising down the road. Harley describes them as such: A spiral-shaped, chain-driven primary balancer located in the crankcase manages the primary vibration created by the crank pins, pistons and connecting rods, and also a “rolling couple,” or side-to-side imbalance, caused by the off-set cylinders. A small secondary balancer located in the front cylinder head between the camshafts complements the primary balancer to further reduce vibration.

On the new Nightster, you have six gears to row through, with a cable actuated clutch. The six-speed transmission shift system features roller bearings to support the shift drum and Teflon-coated shift shaft support bushings to minimize frictional losses and optimize shift quality. The semi-dry transmission cavity should reduce parasitic power loss.

Sounds like a pretty modern package with some enticing pros, so were there any cons? We set off from our hotel in Santa Barbara, CA to find out.

Where the footpegs meet the road

Well, first we set off a mile down the road for some urban photos. That couple miles of riding around town was actually more telling than you might think. Taking off with the Nightster in Sport mode, I found the throttle to be a bit abrupt and although the lightweight motor spins up quick into its rowdy mid-range, it didn’t have that quintessential really low-end torque that we’ve come to love from V-Twins. It’s been a long while since I’ve been on a Sportster, 883 or otherwise, and I haven’t ridden the Sportster S. Still, my initial thought was that I expected more bottom end.

I quickly switched to Road mode while we were cruising around town which helped smooth things out quite a bit, though some on/off throttle jerkiness prevailed. This seemed to be the ticket for general riding on the Nightster, but as soon as we got up into the hills and tight backroads stretched out into faster flowing ones, the train of at least the first four or so Nightsters I was trailing quickly sashayed through the canyons, wheel to wheel and sometimes side by side, confidently. The pace was good, perhaps representative of the average-to-fast Sportster riders out there, but the Nightster goads you into pushing the limits well past its claimed 32-degrees of lean angle with its raucous mid-range that pulls hard toward its 9500 rpm redline. That’s 500 more revs than the Sportster S. During our long photo passes we began filing down our footpegs – and boots in some cases. The footpegs aren’t any wider than they need to be.

The 975T Revolution Max engine has the same mid-range that I believe I’ve referred to as stonkin’ more than a few times already. Although the T is meant to differentiate that this is the torque-tuned version, the mid- to top-end power delivery, and unfortunately the lack of really low low-end reminded me of the PA’s engine character. Out in the canyons and into Sport mode, the Nightster cares not that it is a cruiser. The thing rips.

As you’ve well exceeded your 32 degrees of lean angle and the folding footpeg is giving way to your foot or hard parts you may not want to be dragging, the Nightster feels perfectly planted. The Showa suspension is on the stiff end of the spectrum as it only has three inches of travel in the rear and 4.5-inches up front to work with, but the damping is better than I remember on previous H-Ds. Sharp bumps will still attempt to compact your spine, but at least the mid-mount controls give you a chance of taking it on the foot instead of up your, ahem, rear end. Don’t forget, it was the Sportster’s predecessor, the K line which was the first Harley-Davidson to offer hydraulic suspension on both wheels. You’ve got to start somewhere.