American Ironhorse Texas Chopper Motorcycles in Houston

Being offered is a 1979 Honda CR250, Racer. No expense was spared in the building of this bike, it is like new with only 3 heat cycles on the engine. The engine has all new OEM honda bearings, seals and gaskets, new steel and fiber clutch plates, New Oem Honda rod kit, The cylinder has just been Nikasil plated by powerseal to standard bore, it has a new wiseco pro-lite piston, rings, bearing, pin and clips.

Less than 7 hours on new Wiseco Top AND Bottom end (Built by Chris at 2 Stroke Motorsport) Rebuilt Front brake master cylinder New front brake pads Carb rebuilt and jetted New reeds New Pro Circuit exhaust flange New clutch New FMF exhaust New fork protectors FMF Turbine Core Spark Arrestor New Pro Taper Bars and grips Pro Circuit adjustable clutch perch Hour meter installed after build New bodywork fastener kit New front and rear brake protectors Suspension untouched by me, but has Factory Connection sticker??? New fuel cap vent Comes with fuel can, stand, factory manual, and Bill of Sale Only selling to fund new road race project. I know I will regret it...

2003 Honda CR85R Expert $1,200. Runs well. No problems.

It needs a top end rebuild and I don't have the money to put it in the shop so I'm willing to part it out. Suspension and tires in exceptional condition! I will sell the Front end for $380 WITH the triple tree.

THIS IS BEING RELISTED DUE TO THIS NON-PAYING BIDDER FROM BELGUIM (oflash23) PLEASE DO NOT BID IF YOU DONT PLAN ON PAYING FOR IT. 1979 Honda CR-250, this is a complete from the ground up race build, this started with a very low hour machine. Its a race bike and draws attention wherever its seen.